If I am to have the 3mm inner bleed the example below shows what happens, as expected it picks up the opposite page on the spread (which for printing purposes would not be on the same sheet): Remembering when it comes to printing (as the document is going to be saddle-stitched) the pages on the working document will not be on the same sheet in the booklet. So if I were to change the document to have facing pages (which it does not currently because I wanted to have bleed on all sides). I hope this made some sense, as it confused me even trying to explain. Is the only way to do this by creating master pages for the left and then for the right and then applying them manually to the document? If I want the odd and even pages to have alternating master layouts (i.e., so the page number is always in the outside corner of the booklet), I need to set up the document in spreads (or facing pages) then I do not have get bleed down the centre of the spread from page to page which I need when sending through to the printer. ![]() ![]() The end result will bee a saddle-stitched booklet that the printer would like as a single page PDF, but my problem is that I can not use the benefit of left and right master pages unless I use spreads in my document. I am creating a large pricelist with multiple (15) master pages (for example, pages 1–10 have Master A and 10–20 have master B and so on).
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |